Norsk Orientering

Innlegg i Feilsøking > Freeze for few seconds middle of printing

  • Frederick Gragg
    tirsdag 26 oktober 2021 klokken 12.18

    For the preparation of exam , you can rely on the TestsMate exam preparation. https://www.vingle.net/posts/4073283 is one of the best preparation plateform , the Tests materials of TestsMate is outstanding & it will ensure your success in the final Exam easily.

  • Ahmed Ball
    onsdag 3 juni 2020 klokken 9.31

    The old version is not right most of the people are still using this, and they are facing many problems, so that’s thy established companies are selling these all old versions. The latest model is seen as the wise essay company, and this printer is working excellently within one minute more than 100 pages print.

  • Gogen Timber
    lørdag 14 juli 2018 klokken 12.40

    Hi,

    I was using the old 3.xx version without any issues for a long time. Today, I have updated to version 4.0, and noticed my printer is freezing for few seconds (couple of times in a print), and continues normally, but this causes melting on object where hot end pause.

    I haven't changed anything. My printer is Robo3D R1+ without modifications.Does anyone have same issue? If not, I will do a clean installation.

     

    Please help

    I didn't find the right solution from the internet.

    References:

    https://forum.simplify3d.com/viewtopic.php?t=7871

    Explainer Video Companies

    Thanks

Annonser

IOF Eventor